Using the Custom planter generator
Create a decorative outer planter around a tapered nursery pot or another measured insert. This tool uses Barrett Clark's Printed Planter generator and its bundled BOSL2 library. Enter the insert's top diameter, bottom diameter and height, then choose a plain, ridged or diamond-patterned exterior.
- Measure the insert at its top rim and bottom, and measure its full height. The bottom diameter must be smaller than the top diameter.
- Choose wall thickness, radial rim clearance and an exterior pattern. Enable drainage holes only if the finished planter should drain.
- Check the complete outside dimensions against your printer bed, then export a small fit sample or the full planter for slicing.
Insert dimensions and finished planter size
The three insert dimensions describe the object that goes inside the planter. They are not the finished outside dimensions. The generated shell adds wall thickness, space around the body, a rim seat, a floor and an air gap below the insert. Raised patterns expand the outside envelope further, so read the live measurements before export.
Rim clearance is radial: increasing it by 0.2 mm adds approximately 0.4 mm to the seat diameter. The browser preset uses a 3 mm floor, a 5 mm gap below the insert and an 8 mm rim seat. Optional drainage adds six 4 mm holes through the floor. A model without drainage holes is not a guarantee of a watertight print; check your material and finished print.
Default values and parameter ranges
- Insert top diameter
- Default 100 mm; range 60 to 200 mm
- Insert bottom diameter
- Default 75 mm; range 40 to 160 mm
- Insert height
- Default 85 mm; range 40 to 200 mm
- Wall thickness
- Default 3 mm; range 2.5 to 5 mm
- Rim clearance
- Default 0.4 mm; range 0.2 to 1.2 mm
- Pattern
- Ridges; choices: Plain, Ridges, Diamonds
- Pattern repeats
- Default 16 ; range 8 to 32
- Drainage holes
- Off
Default mesh example: 116.8 × 116.8 × 93.1 mm. These are dimensions of the rendered source model, not measurements of a physical print. Your live preview reports the outside dimensions for your selected values.
Original design: Barrett Clark and BOSL2 contributors. License: MIT; BOSL2 BSD-2-Clause. Original project and license. Source revision 45aa26380e09. Download Source + license above to retain the source, notices and your parameter setup.










