Using the Divided organizer tray generator
Build a freestanding organizer tray around a measured space or a set of small parts. This generator uses Sofian Audry's OpenSCAD Tray with straight compartment geometry. Width, depth and height are specified directly in millimeters, rather than Gridfinity units.
- Measure the available space and enter the tray's outside width, depth and height.
- Choose columns, rows and wall thickness to divide the interior.
- Inspect the compartment layout and outside dimensions, then export the STL for your slicer.
Outside size is different from compartment space
The default tray is 110 mm wide, 80 mm deep and 25 mm tall, with 3 columns, 2 rows and 2 mm walls. Those first three values describe its outside dimensions. Walls and internal dividers take up room, so dividing the outside width by the column count will overstate the usable compartment space.
Use the preview to check the divider arrangement, and leave room around the objects you plan to store. The tray is a freestanding organizer and does not use a Gridfinity mounting base. Its source ZIP retains the upstream notices and the small GoodPrints3D adapter that supplies the browser controls.
Default values and parameter ranges
- Width
- Default 110 mm; range 40 to 240 mm
- Depth
- Default 80 mm; range 40 to 240 mm
- Height
- Default 25 mm; range 12 to 80 mm
- Columns
- Default 3 ; range 1 to 6
- Rows
- Default 2 ; range 1 to 6
- Wall thickness
- Default 2 mm; range 1 to 4 mm
Default mesh example: 110.0 × 80.0 × 25.0 mm. These are dimensions of the rendered source model, not measurements of a physical print. Your live preview reports the outside dimensions for your selected values.
Original design: Sofian Audry. License: GPL-3.0-or-later. Original project and license. Source revision 9fc472032fad. Download Source + license above to retain the source, notices and your parameter setup.










