Using the Lightweight Gridfinity bin generator
Make a lighter-style Gridfinity bin with a thin floor and configurable compartments. This generator uses the lightweight bin in Gridfinity Rebuilt. It keeps footprint and height controls familiar, while giving you a different floor construction to inspect in your slicer.
- Choose the Width and Depth using the same 42 mm grid spacing as other Gridfinity parts.
- Set Height, Columns and Rows, then compare the outside dimensions with your available storage space.
- Inspect the exported floor and bottom layers in your slicer before choosing print settings.
Check the thin floor in your slicer
The browser preset uses the upstream lightweight model with its bottom-layer setting set to 1. That is a model parameter, not a promise of one slicer layer: the actual layer count depends on your slicing configuration. Check the preview of the floor and first layers before printing.
The default 2 by 2, 3-unit bin has the same approximate 83.5 by 83.5 by 24.5 mm outside envelope as the regular bin. Similar outside dimensions do not establish the same strength, print time or material use. Use the regular bin generator as a comparison and base any savings on your own slicer results.
Default values and parameter ranges
- Width
- Default 2 grid units; range 1 to 5 grid units
- Depth
- Default 2 grid units; range 1 to 5 grid units
- Height
- Default 3 7 mm units; range 2 to 10 7 mm units
- Columns
- Default 1 ; range 1 to 6
- Rows
- Default 1 ; range 1 to 6
Default mesh example: 83.5 × 83.5 × 24.5 mm. These are dimensions of the rendered source model, not measurements of a physical print. Your live preview reports the outside dimensions for your selected values.
Original design: Kenneth Hodson, Zachary Freedman and contributors. License: MIT. Original project and license. Source revision 910e22d8607f. Download Source + license above to retain the source, notices and your parameter setup.










