Using the Custom comb generator
Explore comb geometry by changing tooth count, tooth length, width, gap and spine size. The browser preset uses Jerry van Heerikhuize's comb generator with a plain spine. It produces an actual mesh for inspecting spacing and overall size before you export an STL.
- Choose a tooth count and set the width and gap for the spacing you want.
- Adjust tooth length, spine width and overall thickness.
- Check the complete outside dimensions and examine the tooth tips and gaps in your slicer.
Tooth width and gap are separate controls
Tooth width controls each tooth's material width, while tooth gap controls the space between neighboring teeth. Changing either value can change the overall length of the comb. Increasing the number of teeth can also make the finished part longer, so use the live bounding dimensions to check the complete footprint.
The default 24-tooth mesh measures about 74.5 by 37.5 by 3 mm. The browser adapter suppresses the personalization stamp so it can run without external fonts. Text and SVG personalization from the upstream project belong in the original desktop OpenSCAD workflow, rather than a browser control on this page.
Default values and parameter ranges
- Teeth
- Default 24 ; range 5 to 70
- Tooth length
- Default 25 mm; range 10 to 50 mm
- Tooth width
- Default 1.5 mm; range 0.5 to 4 mm
- Tooth gap
- Default 1.5 mm; range 0.5 to 4 mm
- Spine width
- Default 12 mm; range 6 to 30 mm
- Thickness
- Default 3 mm; range 2 to 6 mm
Default mesh example: 74.5 × 37.5 × 3.0 mm. These are dimensions of the rendered source model, not measurements of a physical print. Your live preview reports the outside dimensions for your selected values.
Original design: Jerry van Heerikhuize. License: Apache-2.0. Original project and license. Source revision 20d758478d12. Download Source + license above to retain the source, notices and your parameter setup.










