EOS FORMIGA P 110 Velocis vs Formlabs Fuse 1+ 30W: SLS Buyer Comparison
The EOS FORMIGA P 110 Velocis and Formlabs Fuse 1+ 30W are polymer selective laser sintering systems, but their published build volumes and laser types differ. Start with the size and material route your parts need, then compare a complete powder-handling cell, local support and representative finished parts. This comparison uses manufacturer specifications; it is not a hands-on test.
For more on the EOS system, see the FORMIGA P 110 Velocis printer hub and buyer guide. For the Formlabs system, see the Fuse 1+ 30W printer hub and buyer guide.
Specifications at a glance
| Specification | EOS FORMIGA P 110 Velocis | Formlabs Fuse 1+ 30W |
|---|---|---|
| Process | Polymer SLS | Polymer SLS |
| Build volume | 200 × 250 × 330 mm | 165 × 165 × 300 mm |
| Laser | One 30 W CO2 | 30 W ytterbium fiber |
Sources: EOS system data sheet and Formlabs SLS specifications. Both figures describe nominal build space. They do not guarantee that a particular part fits, or predict usable yield, job time or part quality.
Build volume and part fit
EOS lists a larger nominal dimension on each axis. This can matter for a part that cannot be oriented within the Fuse volume, or for a build layout that needs more room. Check the actual geometry, orientation, clearances and nesting rules with each supplier. The extra volume alone does not establish higher throughput or lower part cost.
Materials and qualification
EOS lists PA 1100, PA 1101, PA 2200, PA 2201, PA 3200 GF, EOS TPU 1301 and Alumide in its system data sheet. Formlabs lists Nylon 12, Nylon 12 Tough, Nylon 12 White, Nylon 11, Nylon 12 GF, Nylon 11 CF and TPU 90A for the Fuse 1+ 30W. Formlabs also describes an open material mode. Confirm the current conditions, equipment and support for any proposed powder and process with the supplier.
Similar material-family names do not make powders, settings or finished-part properties interchangeable. Request the exact material and process documentation and evaluate representative printed and finished parts against the intended mechanical, dimensional and environmental requirements.
Workflow and costs
Both choices require a plan for powder storage, build preparation, cooling, unpacking, recovery, cleaning and finishing. EOS lists an unpacking and sieving station, blasting cabinet and mixing station as optional accessories. Confirm what is included in each quote, which ancillary equipment and utilities are required, and how material changes and maintenance are handled.
Compare complete installed quotations, training, service, software, consumables, labor and expected utilization. Obtain current site-preparation instructions and material safety data sheets, and review ventilation, powder exposure, fire protection and local requirements with qualified personnel. No current price, availability or measured production cost is asserted here.
Which should you consider?
Consider the FORMIGA when its larger stated build space or an EOS-released material route matches the work and the team can support the full installation. Consider the Fuse 1+ 30W when the intended parts fit its stated space and an appropriate Formlabs material and workflow meet the application. Ask both suppliers for a representative build, a complete quotation and the current configuration before deciding. Outsourcing can be a practical first step when demand or facility readiness is uncertain.