DISCOVERED ON SKETCHFAB
Filament-Reel-Holder
Created by Erik (opens in a new tab)
Get files, available formats, and printing instructions from the original listing.
- License declared by creator
- CC BY 4.0 (opens in a new tab)
- Published on Sketchfab
- Oct 1, 2018
- Listing checked
- Nov 17, 2026
- Printing suitability
- Creator tagged; unverified
GP3D review
Source-based · Not test-printed by GP3D
Recommendation pending for Makers exploring adaptable filament reel holders. GP3D assessmentThe described spacer and axle arrangement is a potential starting point for a maker willing to investigate fit, but the available description does not establish dimensions, capacity or reliable operation. This source-based assessment cannot recommend it for a particular reel or workload without further evidence. [1]
GP3D assessmentErik describes a filament-reel holder with glued base pieces, individually designed reel spacers and an axle that acts like a wedge. The creator says they printed and reworked the model; GP3D has not print-tested it. [1]
Print difficulty: Not established. GP3D assessmentThe described assembly includes gluing two parts on each side and accommodating individually designed spacers. The supplied description does not provide enough preparation or assembly detail to grade the overall difficulty reliably. [1]
- GP3D assessmentThe creator says each side of the base consists of two parts glued together. Plan for an adhesive assembly step; the supplied description does not identify an adhesive or give a bonding procedure. [1]
- GP3D assessmentThe creator says the reel spacers can be designed individually and shows two samples. This may appeal to someone comfortable adapting parts, but the description does not establish compatibility with a particular reel. [1]
- GP3D assessmentThe creator describes the axle as a kind of wedge that keeps the spacers in place. Dimensions, load capacity, print settings and performance are unverified, so check fit and stability before relying on it. [1]
0 public comments checked. Checked Nov 17, 2026.
Sources checked
FROM THE MAKER
About this model.
I modelled, printed and reworked this model as a filament-reel-holder for a 3D-printer. The base consist of two parts ech side, which are glued together. The spacer to hold the reel can be designed individually (two samples are shown). The axis itself works as a kind of wedge, keeping the spacers in place.




