Watertight Vase-Mode Prints: A Repeatable Leak Check
Vase mode does not guarantee a watertight container. A continuous spiral wall can still contain gaps, thin regions or a leaking base transition. Test the finished container with water in a protected location before relying on it around furniture or other damage-sensitive surfaces.
This is a check for decorative water containers. It does not establish food-contact suitability, pressure capability, chemical resistance or long-term service life.
What the published evidence says
Prusa's open-container investigation discusses material, extrusion, wall and layer effects on leakage. It also notes that changing flow can affect dimensions and finish. Its findings are evidence that watertightness is process-dependent, not a universal preset for every vase-mode model.
Keep a normal multi-perimeter container and a spiral single-wall container separate in the comparison. Settings that add walls to the first may not exist in the same way for the second.
Inspect before adding water
- Check the sliced wall path for thin regions, abrupt geometry and incomplete base coverage.
- Inspect the cooled print for visible gaps, damage and a poor wall-to-base transition.
- Use the actual material, nozzle and supported profile rather than compensating for a clog with arbitrary excess flow.
- Place the container in a secondary tray away from electrical equipment.
Do not fill a questionable print on an unprotected desk to find out whether it leaks. A secondary container makes the observation less costly without changing the test question.
A seven-day observation plan
As an example protocol, record the empty dry mass, fill to a reproducible level, and note the filled mass. Inspect at one hour, 24 hours, 72 hours and seven days, recording external wetness, tray water and mass where the scale is suitable. These intervals are a proposed observation plan, not reported GoodPrints3D test results or a qualification standard.
Use a nonleaking control container with similar exposed water area in the same environment to help interpret evaporation. Do not assume every gram of loss is a leak, or that subtracting control loss gives a perfect leakage measurement. Different opening geometry and absorption can still affect the result.
Use the location of leakage
- Base only: inspect coverage and the base-to-wall transition.
- Isolated wall pinholes: inspect local path width, extrusion consistency and defects.
- A repeatable height band: compare that feature with the sliced geometry and any process change.
- Delayed wetness: record exposure duration rather than declaring a short initial check a lifetime pass.
Change one thing and repeat
Correct the identified process or design issue, then repeat the same observation with the same fill and inspection rules. A thicker path or different layer choice can change dimensions and appearance, so inspect those as well.
Record model_revision, material, nozzle, line_width, layer_height, base_settings, fill_level, observation_time, mass, external_wetness. Report what passed, for how long and under which conditions. Seven days without visible leakage is a useful observation, not proof against every future use.
Evidence note: this guide combines the cited public documentation with GoodPrints3D analysis. Any numerical example labeled illustrative uses assumed inputs; it is not a GoodPrints3D equipment test. Sources reviewed November 19, 2026.
Sources and references
- Prusa: watertight open models: process-dependent leakage and dimensional tradeoffs