Filament Hygrometer Calibration: Check the Low-RH Limits
A single salt or reference check does not prove a hygrometer is accurate across the low-humidity range used for filament storage. Check the exact instrument's specification, compare it under controlled conditions and keep adjustment separate from measurement.
A display that reads 10% RH repeatedly may be stable, near its lower reporting limit or offset from the reference. Resolution tells you the display step, not the size of the possible error.
Read four specifications
- Range: where the instrument reports or is specified to operate.
- Accuracy: the stated error under defined conditions.
- Resolution: the smallest reporting increment.
- Response and stability: how it reacts and drifts over time.
Sensirion's documentation illustrates that these are separate properties and can depend on conditions. Do not assign that sensor's performance to a generic boxed hygrometer unless its actual design and specification support it.
A comparison is not automatically calibration
Placing two devices together can reveal disagreement. If neither is a qualified reference, it does not establish which is right. Three agreeing low-cost devices can still share a bias or reporting floor.
For a meaningful check, use a suitable documented reference and record temperature, equilibration, placement and the reference's uncertainty. Follow the instrument and reference instructions; avoid exposing sensors to unsupported liquids or chemicals.
Why one point is not enough for every use
NIST's published saturated-salt reference work tabulates equilibrium humidity as a function of temperature with uncertainties. It supports controlled reference conditions, not the idea that an uncontrolled household check creates a traceable calibration.
A check near roughly 75% RH, for example, can reveal an error there. Applying the same offset at 10% assumes the instrument's error is constant across that range. That assumption needs evidence. A reference near the intended operating region is more relevant to a low-RH decision.
Use a reproducible check
- Identify the exact device and its specified RH and temperature limits.
- Use an appropriate reference method under its instructions.
- Allow equilibration and record both temperature and RH.
- Repeat after repositioning or on another day to examine consistency.
- Record the observed difference before making any supported adjustment.
Do not call an adjustment successful merely because the display now matches one target. Keep the before and after readings and verify the region relevant to storage.
Use trends when absolute accuracy is limited
A device with known limitations can still help show that a box changes after opening or that desiccant performance is drifting. Compare the same location and temperature. Avoid claiming that a two-percentage-point change is significant when the measurement uncertainty is larger.
Finally, remember that even a well-characterized hygrometer measures surrounding air. It does not assay filament moisture or certify that a drying cycle completed. Keep storage monitoring and material recovery as separate records.
Record device, reference, reference_uncertainty, temperature, equilibration, RH_reading, difference, adjustment, date.
Evidence note: this guide combines the cited public documentation with GoodPrints3D analysis. Any numerical example labeled illustrative uses assumed inputs; it is not a GoodPrints3D equipment test. Sources reviewed November 19, 2026.
Sources and references
- NIST: humidity fixed points of saturated aqueous solutions: temperature-dependent equilibrium references and uncertainty
- Sensirion SHT4x datasheet: range, accuracy and measurement conditions