Filament Drying Cost Per Spool: kWh and Batch Allocation

Drying electricity cost equals measured cycle energy in kWh multiplied by your electricity rate. To estimate cost per spool, divide by the spools that completed the relevant drying cycle. Heater wattage multiplied by the timer is an assumption about continuous power, not a measurement of a thermostat-controlled dryer.

The useful question is not just whether a cycle is cheap. It is whether the equipment can perform the exact filament maker's supported recovery process. A cheap cycle that leaves an unsuitable spool does not become good value because the electricity line is small.

Measure the complete cycle

  1. Confirm the exact filament grade, spool limits and supported drying instructions.
  2. Use a suitably rated outlet meter and record its cumulative kWh before startup.
  3. Include warm-up, the complete supported cycle and any defined cooldown or maintenance period.
  4. Record the final kWh, duration, number of loaded spools and whether the machine was also feeding a printer.

Use the same boundary for comparisons. Measuring one dryer alone and another together with a printer produces numbers that answer different questions. Ambient conditions, loading and ventilation also need to be recorded.

Worked example: one cycle, three spools

Suppose a cycle uses an illustrative 0.54 kWh and your assumed tariff is $0.24/kWh. Electricity is 0.54 x 0.24 = $0.1296 for the cycle. If all three spools complete the intended process, equal allocation is about $0.043 per spool.

If only two spools complete the required process, allocating that same electricity across successful recoveries gives about $0.065 each. This is bookkeeping for assumed inputs, not a claim about a particular dryer or proof that a spool is dry.

Rated watts and measured kWh are different inputs

A hypothetical device drawing 300 W continuously for six hours would use 1.8 kWh. A device whose heater cycles may average something else. Do not publish that 1.8 kWh as a measured result merely because 300 W appears on a specification label.

Keep total-cycle and marginal estimates distinct. An empty-cycle measurement can help investigate the equipment, but subtracting it from every loaded cycle does not describe the electricity actually billed for that cycle.

Allocate shared drying fairly

  • Similar spools, same cycle: equal allocation can be a transparent internal convention.
  • Different grades or cycle requirements: record which spools completed their required process. A common timer does not establish equivalent treatment.
  • Drying while printing: keep printer and dryer energy separate if the measurement setup allows it; otherwise label the total as a combined cell reading.
  • Storage maintenance: record ongoing electricity separately from recovery drying so a short cycle is not compared with all-day maintenance.

What belongs beyond the electricity line?

For a purchase decision, add equipment cost, operator handling, capacity, failed recoveries and material loss. Do not extend a drying temperature or time beyond supported limits to chase a lower cost per batch. Prusa's drying guidance is useful context, but the instructions for the actual spool and equipment remain the process boundary.

Use cycle_kWh, tariff, loaded_spools, successful_recoveries, cycle_minutes, equipment, grade as the minimum log. Feed the measured average into the electricity calculator when appropriate, and keep the raw kWh beside it for later checking.

Evidence note: this guide combines the cited public documentation with GoodPrints3D analysis. Any numerical example labeled illustrative uses assumed inputs; it is not a GoodPrints3D equipment test. Sources reviewed November 19, 2026.

Sources and references

Related GoodPrints3D guides and tools