DISCOVERED ON PINSHAPE

1.75mm Filament Clip

Created by cworthdynamics (opens in a new tab)

CC BY 4.0671 Pinshape likes
View model on Pinshape (opens in a new tab)

Free files on Pinshape. Sign in there to download.

Files listed
2 (STL)
Pinshape downloads
10,443
License declared by creator
CC BY 4.0 (opens in a new tab)
Published on Pinshape
Not supplied
Listing checked
Nov 17, 2026
Printing suitability
Print files listed; unverified

FROM THE MAKER

About this model.

SummaryI have tried every filament clip I could find and there are some good ones but none fit all my criteria. Some of the common problems I ran into were: Too long to fit on full spool Not tight enough Easily dislodged when spools stacked next to each other I designed these to address those issues and so far they have been working very well. There is a 4mm wide version for MakerBot spools and a 5mm wide for other misc spools. Both are for 1.75mm filament. InstructionsI would recommend using a raft and going slow since these are small. I use one shell and a high fill, at least 30 - 50%. Getting the hole the exact right size is difficult, so you may need to drill it out.